Molybdenum ore flotation
The beneficiation method of molybdenum is mainly flotation. In the deep selection of molybdenum-based ores containing trace amounts of copper, a partial mixing-priority flotation process was employed.
Process Introduction
The beneficiation method of molybdenum is mainly flotation. In the deep selection of molybdenum-based ores containing trace amounts of copper, a partial mixing-priority flotation process was employed.
1, jaw crusher
In order to achieve a good grinding effect and improve the accuracy of flotation, two-stage crushing is generally used. First, the bulk molybdenum ore is coarsely crushed in a jaw crusher and then sent evenly to the impact crusher for further medium-fine crushing. Next, it is sieved into a variety of different specifications by a circular vibrating screen. The unqualified materials are sent back to be re-broken, and the materials that meet the conditions are sent to the next link.
2, molybdenum ore ball mill
The processing capacity of the molybdenum ore beneficiation ball mill is 0.65-615 t/h, and the feed size is less than 25 mm. The role of the molybdenum ore ball mill is to separate the gangue from the molybdenum ore by grinding.
3, spiral classifier
The molybdenum ore slurry after grinding by the ball mill is sent to a spiral classifier for classification work, the qualified slurry enters the silo, and the unqualified re-grinding is returned to the ball mill.
4, flotation machine
Molybdenum ore flotation machine is recommended to choose XJK type, SF type or JJF type flotation machine. Flotation is a relatively important operation process in the molybdenum ore beneficiation process. Therefore, the process requirements should be strictly followed in order to ensure a higher quality molybdenum concentrate.
5, thickener
The molybdenum concentrate after flotation contains water and needs to enter the concentrated concentration and dehydration in the thickener. Here, a thickener is used.
Production Example
Process Flow Chart
The beneficiation method of molybdenum is mainly flotation. In the deep selection of molybdenum-based ores containing trace amounts of copper, a partial mixing-priority flotation process was employed. The specific process is:
1. Three times of crushing process, which are coarse crushing, secondary crushing and fine crushing;
2. The ore is uniformly fed to the mine through vibration, and sent to the ball mill for crushing operation;
3. Secondary ball mill grinding;
The coarse selection is carried out in the case of coarse grinding, and the obtained coarse concentrate is further ground and further selected. The regrind coarse ore concentrate is small, and the mineral monomer dissociation can be realized. In the high-grade and high-recovery concentrate, the energy consumption is reduced, the energy consumption is reduced by 30%, and the recovery rate is increased by more than 10%.
4, graded work
5, two rough selection, multiple selection of operating procedures.
The materials and chemicals are sent to the mixing tank to be fully stirred, sent to the flotation machine for flotation operation, and the pharmaceutical system is strictly implemented in the rough selection section to control the dosage of the medicament, so that “the early harvest can be received early”, and the cycle is reduced and Inaction loss; make full use of the secondary enrichment of the foam, and through the appropriate no water, the concentrate foam is washed to reduce impurities in the foam to achieve the purpose of enhanced flotation.
Note: The molybdenum ore beneficiation production line can be applied to the refractory molybdenum ore with a single molybdenum ore with complex nature, tightly symbiotic sulphide minerals and fine granules.
